tag:blogger.com,1999:blog-8458866935778172402.post2746354498786158757..comments2024-03-26T17:34:49.565-04:00Comments on The Eaton County Woodworker: Hand planed moldings for my dresser.Zach Dillingerhttp://www.blogger.com/profile/04253489360440424953noreply@blogger.comBlogger4125tag:blogger.com,1999:blog-8458866935778172402.post-29062507572980626612014-12-18T08:06:48.963-05:002014-12-18T08:06:48.963-05:00By planing the back after cutting to shorter lengt...By planing the back after cutting to shorter lengths and setting your planing stop low in combination with a doe's foot, you can use a sharp smoothing plane to just clean up to to gauge lines. Just another alternative, Ford.Joshua Kleinhttps://www.blogger.com/profile/16992478179847033132noreply@blogger.comtag:blogger.com,1999:blog-8458866935778172402.post-65266553703507867192014-12-15T05:35:11.791-05:002014-12-15T05:35:11.791-05:00Some profiles might allow for mating and planing s...Some profiles might allow for mating and planing square after being planed with a complex profile but I can hardly think of doing an advantage of doing so as compared with ripping and dimensioning stable stock (There is no guarantee that a board of this length will remain as straight as when part of the wider plank.) and then planing with a stickingboard and stop.Potomackerhttps://www.blogger.com/profile/02047837559244141708noreply@blogger.comtag:blogger.com,1999:blog-8458866935778172402.post-89523622378368617432014-12-13T10:30:19.157-05:002014-12-13T10:30:19.157-05:00To hold struck moulding for planing, turn one piec...To hold struck moulding for planing, turn one piece over and put it on the other, flipped around 180 degrees. The two pieces together form a flat surface.Gary Cookhttp://www.hackneytools.comnoreply@blogger.comtag:blogger.com,1999:blog-8458866935778172402.post-42351177646800049892014-12-12T13:00:53.626-05:002014-12-12T13:00:53.626-05:00Zach,
I have found it difficult to hand plane t...Zach,<br /> I have found it difficult to hand plane the back of a molding after it is sawed off. I have switched to dimensioning the blank to final size before sticking the molding. This has worked very well for me on my last few moldings. What is your method for holding the stuck molding for planing?<br /><br />Ford Anonymousnoreply@blogger.com